Maxtrac LS conversion problem

This forum is for discussions regarding all aspects of Motorola radio programming, including hardware, computers, installation and use of RSS/CPS, firmware upgrades, and troubleshooting. There are subforums for discussions of codeplugs, and also for software/firmware release notes and issues.

Moderator: Queue Moderator

Post Reply
jcoupejr
New User
Posts: 1
Joined: Sat Oct 13, 2007 9:19 am

Maxtrac LS conversion problem

Post by jcoupejr »

Hi everyone,

I have 2 Maxtrac 800 mHz. conventional radios that I want to convert to LTR operations.
I blanked both logic boards and tried to initialize the boards with Maxtrac LS software as LTR boards, however I get an error message "92 - TX Emergency signalling sytem is missing". This pops up a few seconds after starting to initialize the boards. I am using a known good Maxtrac LS firmware chip. Anyone ever run into this before? Any Ideas?

I am using version 2.03.00b Maxtrac LS software. I do not have access to the latest version, 3.00.00.

Thanks

Jack Coupe
Top
Post Reply

Return to “Radio Programming”