MT2000 RSS ? programming errors

[m109a3]

Hi I have a MT 2000 h01rdh9aa7an , I have the old dealer computer and software kit . I cant find the RSS I need in my kit can someone tell me what RSS i need for this UHF radio the RSS I have MTX xxxx Reads the radio then when I try to edit the Modes
I get the radio not supported ?? ?

I may not be loading the correct stuff I have a large list of software I hope I have it

P133 dos win95 48MB ram !GB HDD
Real moto rib and cables etc ..

Just need to know what I need to program this radio maybe I'm over looking something thanks

[Tom in D.C.]

If you have the correct RSS then the problem is likely to be that you're not running true DOS. The W98 so-called DOS is not the same as DOS 6.22 because the W98 version screws up the serial port's communications. Do a search on this Board for the subject as it has been discussed hundreds of times in the past. If you boot into DOS 6.22 your RSS should work fine. Being able to read the radio but not write to it is typical of this situation.

[m109a3]

just to make sure what rss do it need? I see someone said if you had the radio programmed with cps then it will not work in dos rss ?

[Mfire39]

just to make sure what rss do it need? I see someone said if you had the radio programmed with cps then it will not work in dos rss ?

There is no CPS for MT2000's, it's DOS RSS only.

MTS2000's can use RSS or CPS.


-Marc

[Will]

Hi I have a MT 2000 h01rdh9aa7an , I have the old dealer computer and software kit . I cant find the RSS I need in my kit can someone tell me what RSS i need for this UHF radio the RSS I have MTX xxxx Reads the radio then when I try to edit the Modes
I get the radio not supported ?? ?

I may not be loading the correct stuff I have a large list of software I hope I have it

P133 dos win95 48MB ram !GB HDD
Real moto rib and cables etc ..

Just need to know what I need to program this radio maybe I'm over looking something thanks

MTSX.EXE

[m109a3]

I'm still hitting the brick wall , MT2000 the " code plug too new "

using mtsx.exe

UHF
thanks for any help guys

[linkinpark9812]

I'm still hitting the brick wall , MT2000 the " code plug too new "

using mtsx.exe

UHF
thanks for any help guys

It means that that radio's codeplug has been written at some point with a NEWER RSS than what you are using now.

What version do you have now? I heard that the "latest release" was like 6.07, but that some radios were programmed with 6.08, which I heard Motorola didn't even ship to customers when ordering it from them (unless they are doing it now).