how do u know its a rebanded radio

The General forum is where users can discuss any topic regarding Motorola communications equipment - hardware, software, etc. There are also several focused forums on this board, so please take the time to ensure that your questions doesn't fall into one of those categories before posting here!

Moderator: Queue Moderator

Post Reply
ssd
Posts: 111
Joined: Thu Dec 07, 2006 7:50 am
What radios do you own?: mts2000 mod 2 800mhz,as 3 vhf

how do u know its a rebanded radio

Post by ssd »

hi i want to know how u find out if it the radio is rebanded without reading it so when i buy it on ebay and the guy say it wide and narrow band. i dont get it and it ant rebanded thanks vince
resqguy911
Posts: 613
Joined: Sat Jun 26, 2004 3:35 pm

Re: how do u know its a rebanded radio

Post by resqguy911 »

Rebanding has nothing to do with narrowband. Are you talking about 800 or VHF?
"TDMA = digital and same great taste, half the bits"
ssd
Posts: 111
Joined: Thu Dec 07, 2006 7:50 am
What radios do you own?: mts2000 mod 2 800mhz,as 3 vhf

Re: how do u know its a rebanded radio

Post by ssd »

i know 800 mhz is the olny 1 that has rebanding dun. i see on ebay astro sabers that are 800. and the guy say the radio will do wide and narrw. what i want to know is what do i need to look for on 800 mhz radios that will say it will do rebanded stuff. i know wide and narrow is vhf and uhf.thanks
resqguy911
Posts: 613
Joined: Sat Jun 26, 2004 3:35 pm

Re: how do u know its a rebanded radio

Post by resqguy911 »

Well now, if we are talking 800MHz it doesn't really matter as your system manager will provide you with a properly configured radio or the requirements if necessary. Sorry if I thought you wanted to make sure a VHF radio had the elusive 2.5KHz RF board, your statement was a bit cryptic.

http://www.rif.org/
"TDMA = digital and same great taste, half the bits"
User avatar
The Pager Geek
Posts: 1250
Joined: Fri Jun 21, 2002 10:31 pm
What radios do you own?: Disney FRS

Re: how do u know its a rebanded radio

Post by The Pager Geek »

There is some merit to the question, as not all radios will do rebanding due to firmware.

Even if the sys admin will allow him to use the system, the OP should be buying radios with rebanded firmware in them to avoid the need of an upgrade prior to use on the system.

The answer to the question is a question "What is the Host / DSP of the radio?"

tpg
Experienced Provider of Useless Information
N4KVE
Posts: 1652
Joined: Wed Apr 02, 2003 10:35 am
What radios do you own?: APX XTS XTL TRBO 900MHZ

Re: how do u know its a rebanded radio

Post by N4KVE »

Depending on which radio you have, you put it in the "service mode". On an Astro Saber, this means you turn the radio on, & within 5 seconds hit the rear button under the PTT switch 5 times quickly. If you just hear a single beep, it's not rebanded. If however you hear the same tone as when keying up on a trunked Motorola radio, or a Nextel radio, your radio has rebanding firmware. Or, if the host/dsp is R07.71.06/N08.03.05, you're good to go. Again, this applies to an Astro Saber since that's the radio the OP mentioned. GARY N4KVE
ssd
Posts: 111
Joined: Thu Dec 07, 2006 7:50 am
What radios do you own?: mts2000 mod 2 800mhz,as 3 vhf

Re: how do u know its a rebanded radio

Post by ssd »

Ok I have a astro saber 3. Now on my trs. My old mts2k mod1 is on the same trs. When I key up on my as3 its the same as my mts. The as3 is rebanded cuz we have a trs next to are county in the radios. And it rebanded. My mts is not rebanded. The as3 is host I think is. Ro 7.71.06 dsp is 8.03.05. My fcode is 5000080004007. Thanks
ssd
Posts: 111
Joined: Thu Dec 07, 2006 7:50 am
What radios do you own?: mts2000 mod 2 800mhz,as 3 vhf

Re: how do u know its a rebanded radio

Post by ssd »

The mts dos not have the rebanded trs in it and the radio dos not have the rebanded in it
Post Reply

Return to “General Motorola Solutions & Legacy Radio Discussion”