GM 340 Power

[elmanoduarte]

Greetings all

Got a problem in a Motorola GM-340 VHF, it doesn´t power UP !!
I know a few tricks for GM-300, in this situation, but looking to the Gm-340 board, not the same at all !
I do no know what have caused this in this radio. Assuming the polarisation + - in the Power cable is the same has for the Gm-300, do not know what to check !
Any help ???

thanks

[Bill_G]

Hello Elmano. The Gm340 is similar to the CDM series in the US. Yes, the power cable is the same. Other people have experienced a no power up problem with this model.

http://batboard.batlabs.com/viewtopic.p ... =cdm+power

http://batboard.batlabs.com/viewtopic.p ... =cdm+power

http://batboard.batlabs.com/viewtopic.p ... =cdm+power

Hope that helps.

[escomm]

Have you checked to see if it's programmed for ignition sense by putting 12V on pin 10?

[elmanoduarte]

Many thanks for your answers

..well, i do not know what is programmed in this radio, and can´t check it, because it doesn´t power UP !
..about connect 12v in 10 pin, can do it, if i know witch one is the 10 ! Can you help me in that ?,,and you mean connect 12v + or - in that pin ?

thanks

[Bill_G]

That would be +12V. This radio is negative ground.

Telex has an excellent diagram of the CDM series accessory plug in section 4.

http://www.telex.com/UserFiles/Download ... CH-009.pdf

[Andreas]

You can have a radio with a corrupted firmware inside.
Try to read the radio.If it works,the firmware should be ok and you should program the radio with a default codeplug from the CPS folder.

Andreas

[elmanoduarte]

yes,,, but how to program the radio, if doesn´t power uP??,,,there's no connection available for the RIB !...you mean after check the 12v + in PIN 10 ?

thanks