Rigblaster Com port issue

The General forum is where users can discuss any topic regarding Motorola communications equipment - hardware, software, etc. There are also several focused forums on this board, so please take the time to ensure that your questions doesn't fall into one of those categories before posting here!

Moderator: Queue Moderator

Post Reply
unioner101
Posts: 16
Joined: Tue Mar 29, 2005 8:28 am

Rigblaster Com port issue

Post by unioner101 »

I am trying to connect my rigblaster to a CDM1250. I have ensured proper pin layout w/ my RJ45 cable, however I cannot get the computer to link with the rigblaster. According to device manager, the rigblaster (through the serial to usb cable) is assigned to com port 8. However, with the rigblaster provided WinPSK software, com port 8 is grayed out and un-selectable. Also with the echostation software it gives me an error message that there is no connection. I have re-installed the drivers several time.

I was wondering if anyone has had any similar issues or have any ideas.

Thanks
Top
Post Reply

Return to “General Motorola Solutions & Legacy Radio Discussion”