ht1k not rx not tx

[jmr3865]

Hi all,
I have a VHF AN ht1000. Supposedly it was transmitting and receiving before I programmed this radio. The radio is acting fine line it is programed, however, it will not receive or transmit nor show the lights that it is doing the same. Any ideas?

[maxkelley_kc2spy]

You could try reading the radio into RSS and then immediately thereafter writing it back into the radio. If it doesn't let you read the radio, try writing the codeplug (that I *assume* you saved on your computer!) back into the radio.

[fineshot1]

Sometimes when these Jedi radios rf tx brick amp dies it also takes out the receiver.

[jmr3865]

hmm. thanks.

[maxkelley_kc2spy]

So.... what was the issue? Were you able to fix it yet, or no?