Minitor IV programming issue

This forum is for discussions regarding all aspects of Motorola radio programming, including hardware, computers, installation and use of RSS/CPS, firmware upgrades, and troubleshooting. There are subforums for discussions of codeplugs, and also for software/firmware release notes and issues.

Moderator: Queue Moderator

Post Reply
ems133
Posts: 15
Joined: Thu Sep 20, 2001 4:00 pm

Minitor IV programming issue

Post by ems133 »

I am programming 4 Minitor 4's with a new codeplug and two of them worked and 2 don't. Using V2.1.0 software and I get a Serial Communication Error when I try to write the modified codeplug. Works fine to read the existing codeplug. I have also tried using the old DOS Version 6.0 pps with same results. The only changes being made are to the rx freqs. (They are within band) These are 2 ch, non-SV with vibe units. I am using geniune Motorola pager programming cradle, cables, RIB, etc.
Top
ems133
Posts: 15
Joined: Thu Sep 20, 2001 4:00 pm

Re: Minitor IV programming issue

Post by ems133 »

Never mind. Got it by using a slow laptop.
Top
Post Reply

Return to “Radio Programming”