Radio ID when calling with GP360 with 5TVO

[Michel-nl]

We use the 5TVO signalling to call a user on a repeater and is working fine, the radio starts to ring and says "call received" in the display.
But it doesn't show who the caller was, the other radio's who where not called do show the alias from the sender of the 5TVO?
Does anyone know how to set the radio ID, so that the radio that received the specific call knows who the caller was?

[Michel-nl]

Nobody has a clue about this option?

[RADIOMAN2002]

Not a common programming problem over on this side of the pond. I suggest you look at the other radios firmware first then the other radios programming for a clue. Sounds like the radio is not programmed for decode ID or the firmware doesn't support it.

[Michel-nl]

I think that its a firmware thing then. But they have a reasonable recent firmware in it. From witch firmware its supported then?

[borisf]

Could you post the Decoders that are set up for the Personality that is used on the Channel in question?

The issue most likely lies within the Personality settings on the S5 and PTT tabs or in the way variables are used in the Decoders vs. the content of the Contact List.

[Michel-nl]

I could send you a codeplug if you want? Then you can see all of it.
Ifso send me a email to [email protected]