HT750/1250 - does cloning codeplug also clone tuning data?

g8tzl2004 · Post by **g8tzl2004** » Thu Oct 27, 2011 8:22 am

I have 2 identical HT1250/GP380's.

Having programmed around 200 channels into one radio, I would like to just use the same "fully loaded" codeplug and write it to the other radio.

I THINK this should be OK and will NOT result in the tuning values of the 1st radio being loaded into the 2nd radio.

However, I want to make sure that its OK!!! I know with Jedi stuff that you need to be careful in using codeplugs from other radios as you might load the wrong tuning values. The Waris radios have completely separate tuning software so I don't think the codeplug carries any tuning data?

Any views?

Thanks

tvsjr · Post by **tvsjr** » Thu Oct 27, 2011 11:44 am

No, cloning the radio won't clone the tuning partition. Typically, you only have to worry about this with old analog Sabers, and when playing with non-standard RSS tools.

g8tzl2004 · Post by **g8tzl2004** » Fri Oct 28, 2011 1:54 pm

Thanks tvsjr

HLA · Post by **HLA** » Mon Oct 31, 2011 6:36 am

HT750/1250's won't handle 200 channels

g8tzl2004 · Post by **g8tzl2004** » Thu Nov 17, 2011 7:57 am

My "HT1250" is actually a European GP380 which is physically identical but has different firmware.

The Euro firmware has 255 channels!!!

HT750/1250 - does cloning codeplug also clone tuning data?

HT750/1250 - does cloning codeplug also clone tuning data?

Re: HT750/1250 - does cloning codeplug also clone tuning dat

Re: HT750/1250 - does cloning codeplug also clone tuning dat

Re: HT750/1250 - does cloning codeplug also clone tuning dat

Re: HT750/1250 - does cloning codeplug also clone tuning dat