m1225 Repeater

[fire_marshal_bill_1075]

Hello all,

I have all the fixin's to make a repeater out of a pair of m1225's. Here'e the problem. I have the radio's frequncies programmed no problem. I have the dip switches in the RICK programmed for uni-directional. I used pin 8 for the PL/DPL/CSQ detect. When I enable the RICK, the COR light comes on and the TX radio keys up and stays keyed. No matter what I try I can't get it to quit. Both radios are receiving ok. When the TX radio keys up my portable shows it's receiving a signal but won't unmute. All the freq's and TPLs are the same.

Anyone have any suggestions. TIA

[fire_marshal_bill_1075]

OK, I've made some progress. I have pin 8 on the RX radio set for PL/DPL/CSQ, output, active LOW. On the TX I have pin 8 set to NULL, output, active LOW. It's repeating but the portable is still not unmuting. The frequencies are all correct. What the H*** am I missing???

[n3bxh]

I am having the same issue as the OP's last post, any update to this issue???

[Will]

Much simpler than the R.I.C.K. and it can ID too.

http://www.repeater-builder.com/maxtrac ... k-rev2.pdf