Systems Saber top 3 orange buttons don't work

[saberjerk]

Hello
I have a systems saber H44TUK5170CN and I just noticed that the top 3 orange buttons don't seem to do anything.
Is this something I can turn on and off via the rss or is something cooked?
would be nice to change zones and light etc.
thanks

[FireCpt809]

Either the flex is bad or not seated right. Take the case off and check the flex were it goes into the main board.

[saberjerk]

I did already check that flex connection. I might have to buz it out and make sure. I always try for the easy fix first

It's interesting all the buttons on the keypad beep or do something except those top 3 that are completely dead.

Now that might be a clue. Row or column out. I'll take a closer look.

[saberjerk]

You are right. It was a bad keypad.

Not sure if it was the flex or the very fragile circuit printing on the back of the pad

I just replaced the whole keypad. Man those are difficult to peel off and replace without damaging them.

And I verified that regular saber keypads work on systems sabers.

Thanks