H01KDC9AA3DN
402TYJ9413
Using 3.03 sw and keep getting "incompatible codeplug version" I programmed 3 other radios of the same batch and model number with no problem.
TIA
Steve
HT1000 Help programming error
Moderator: Queue Moderator
Re: HT1000 Help programming error
Update
So I figured that if I brick it, it is old and not worth much so let's roll the dice!
I read a good radio, and then went to clone mode. I started the clone with the good radio and after the compatibility read, I quickly moved the cable to the bad radio when it switched to write mode. The write worked and both radios check out just fine.
S.
So I figured that if I brick it, it is old and not worth much so let's roll the dice!
I read a good radio, and then went to clone mode. I started the clone with the good radio and after the compatibility read, I quickly moved the cable to the bad radio when it switched to write mode. The write worked and both radios check out just fine.
S.
-
RadioSouth
- Batboard $upporter
- Posts: 2884
- Joined: Mon Sep 03, 2001 4:00 pm
Re: HT1000 Help programming error
Yup, had done that as well but you don't need to quickly move the cable after the compability read. Just read an identical model radio, make any changes and attach your target radio and do a clone. The compability read will not bong as longs as it's the right band radio, works across the A-B-C-D revisions no problem. Radio must have had a codeplug error as I believe R03.03 was the latest offered before cancellation.