Hello Everyone, I'm new to Motorola so please bear with me as I try to explain.. I recently aquired 2 Astro Spectra W9 and I am told I am missing a cable or something to power these up something to do with the VIP slot on the control head?..what do I need to power these up?..I have the following:
Control Head & cable with the green and orange thin wires. connected to radio slot..
Speaker and Mic
Power cable red/black that plugs into control unit.
Do I need a connector or cable for the VIP slot?...any help thanks.
Dave
Newbie Spectra help
Moderator: Queue Moderator
Re: Newbie Spectra help
As far as I can tell, you have everything you need. Connect the green, orange, and red to +12v, and the black to -, and it should be able to turn on.
Re: Newbie Spectra help
Ok..that's what I thought is there a 12v source out of the VIP?..
- linkinpark9812
- Posts: 120
- Joined: Thu Feb 05, 2009 9:53 pm
- What radios do you own?: Spectra, HT1000, Icom F30
Re: Newbie Spectra help
You mean to grab switch +12VDC output?djpaulino wrote:Ok..that's what I thought is there a 12v source out of the VIP?..
http://www.onfreq.com/syntorx/spectra/c ... s9kvipoins
There are some switched B+. I used it for the relay for my horn ring switch. Probably can't connect a load much bigger.
What are you trying to do?
EDIT: I just saw you have an Astro. Not sure if the pinout is the same as the original Spectra.
Radios I own: Spectra VHF 110W with A7 head, HT1000 VHF, ICOM IC-F30 VHF, and a Puxing PX-888 VHF.
Scanner I own: Radioshack Pro-164
If you want to get around the 16 mode scan limit on the Motorola Spectra, then read this guide and go to the original thread Here!
Scanner I own: Radioshack Pro-164
If you want to get around the 16 mode scan limit on the Motorola Spectra, then read this guide and go to the original thread Here!
Re: Newbie Spectra help
djpaulino wrote:Hello Everyone, I'm new to Motorola so please bear with me as I try to explain.. I recently aquired 2 Astro Spectra W9 and I am told I am missing a cable or something to power these up something to do with the VIP slot on the control head?..what do I need to power these up?..I have the following:
Control Head & cable with the green and orange thin wires. connected to radio slot..
Speaker and Mic
Power cable red/black that plugs into control unit.
Do I need a connector or cable for the VIP slot?...any help thanks.
Dave
First, I would like to point out that there is a major difference between a Spectra radio that the title of your post gave and an Astro Spectra radio. They are some what the same, but you need to keep in the right family when looking for details.
My second comment is that many people don't know that the power switch for the W9 control head is on the bottom right side. This is a slide switch that needs to be moved towards the center of the control head for on and the right side for off. There is no power switch on the face of this control head.
The orange and green wires at the control head end of the cable can both go to a switched ignition source if you want the radio to go on and off with the ignition. The high current 2 pin connector on the rear of the radio needs to be connected to a high current +12 VOLTS. Make sure the black wire goes to ground and the red goes to the vehicle battery through the correct sized fuse. The fuse size is determined by the RF output power rating of the radio.
Jim