Saber III Programming Question

This forum is for discussions regarding all aspects of Motorola radio programming, including hardware, computers, installation and use of RSS/CPS, firmware upgrades, and troubleshooting. There are subforums for discussions of codeplugs, and also for software/firmware release notes and issues.

Moderator: Queue Moderator

Post Reply
User avatar
HeliMan08
New User
Posts: 2
Joined: Fri Dec 21, 2007 3:12 am
What radios do you own?: XTS5000, XTL2500, JT1000

Saber III Programming Question

Post by HeliMan08 »

I was looking into purchasing a Saber III or a Astro Saber III, but I am not sure if I would be ok using Motorola CPS R02.03.00. I was looking over the Readme File and it stated the following.

I am not extremely knowledgeable with Motorola CPS Versions, and wanted to get some input before purchasing the desired radio.
Same Master Key for MTS2000/MCS2000/ASTRO Sabe
r & XTS3000/ASTRO
Spectra/ASTRO 25 CPS.
User avatar
FireCpt809
Posts: 1848
Joined: Sat Jan 19, 2002 4:00 pm
What radios do you own?: Alot..

Re: Saber III Programming Question

Post by FireCpt809 »

Saber and astro sabers don't use the same CPS sabers use DOS based RSS .. also astro sabers use astro CPS not astro 25 CPS
User avatar
HeliMan08
New User
Posts: 2
Joined: Fri Dec 21, 2007 3:12 am
What radios do you own?: XTS5000, XTL2500, JT1000

Re: Saber III Programming Question

Post by HeliMan08 »

FireCpt809 wrote:Saber and astro sabers don't use the same CPS sabers use DOS based RSS .. also astro sabers use astro CPS not astro 25 CPS
Ah ok was not sure, thank you for your input. I am most likely going to be purchasing a Motorola MTS2000 than.
Post Reply

Return to “Radio Programming”