VIP 1 & 2

[rawfire6]

Hello, I'm looking for assistance with relay configuration to enable Horn & Lights off a UHF Range 2 XTL5000.
So far, I have not been able to trigger the relay from a QC II alert to enable the horn & lights. I have been using a standard bosch type relay.
I have tried one relay for both functions and I have tried one relay for each function.

When I activate the QCII tones from another test radio, the mobile I am trying to connect to the horn and lights relay receives the tones and displays "page received"

I now have a tone that emits from the radio as well as the red TX light stays solid on the 05 control head.
My code plug configuration is as follows.

Radio wide/Alarm

Check= Horn & Lights

Check=Permanent Horn & Lights
Duration= 3 sec for both

Check= Two Alarm Option

This appeared to be a simple process, but it is really frustrating. Any assistance would be greatly appreciated.

[jackhackett]

Do you have a button or menu item programmed for H/L? I think that is a requirement.

[rawfire6]

Yes, I have it as a menu item

[jackhackett]

Which way are you trying to connect it, to the VIP Out 1 & 2 on the radio accessory connector or to the VIP port on a control head or DEK?
Have you set VIP up for Horn/Lights under Radio Configuration / Controls? There are settings under DEK A-C or Radio VIP depending on which you are using.

[rawfire6]

I have tried to connect it using the radio accessory connector.

I have set up the appropriate settings under Controls/VIP

[jackhackett]

Okay, wish I could help more, but I haven't done H/L since the GM300 days. I can't think of what might be missing there, other than verifying that you've got the correct pins I don't really have anything else to suggest. Maybe someone that has done H/L on an XTL will chime in here.

[rawfire6]

Thanks for trying. I appreciate it

[Karl NVW]

Check to see whether the VIP pin is supplying A+ or switched ground to the relay. A simple relay wiring schematic should be in the XTL manual.

[jackhackett]

[quote="Karl NVW"]Check to see whether the VIP pin is supplying A+ or switched ground to the relay. A simple relay wiring schematic should be in the XTL manual.[/quote]

They're supposed to be switched ground, the relay diagrams in the installation manual show them connected between the VIP outputs and switched B+, on the dash mount radios the VIP connections are pins 18 and 19, and switched B+ is pin 24. I think they are different on remote mounts and W9 heads, maybe that is the problem?

Rawfire6, can you tell us which configuration you're using, dash or remote mount, and which control head or the radio model number?

[rawfire6]

These radios are remote mount config. Yes, according to the diagrams in the XTL manual, all of those pins settings are correct.

[jackhackett]

Okay, so which connector are you using, J2 on the radio, or J100 on the control head, and do you have anything connected to J400 (yellow) on the control head?