error 01 code while programming system saber 3 uhf

The General forum is where users can discuss any topic regarding Motorola communications equipment - hardware, software, etc. There are also several focused forums on this board, so please take the time to ensure that your questions doesn't fall into one of those categories before posting here!

Moderator: Queue Moderator

Post Reply
xhvx
Posts: 3
Joined: Fri Sep 21, 2001 4:00 pm

Post by xhvx »

I recently got a system saber i was trying to program it however after programming the codeplug the radio displays a flasing
ERROR 01 then it displays the 1st channel programmed. None of the buttons work and the low battery symbol flashes aswell. Any body that knows how to get around this problem their help is greatly appreciated
Top
radioEd
Posts: 424
Joined: Sun Sep 09, 2001 4:00 pm

Post by radioEd »

I gather the radio does not work? Theres a list of Error codes on the batlabs page! If I recall right it says data in the EEPROM could be corrupted? but I hope someone else on the BBS can put some more light on this! good luck Ed
Top
Post Reply

Return to “General Motorola Solutions & Legacy Radio Discussion”