MT2000 RSS question

medic1020 · Post by **medic1020** » Fri Dec 14, 2001 10:52 pm

Does anyone know what the latest version of the MT2000 RSS is? I tried programming an MT2000 with vs. 6.0 and it said the software was too old.

Allan

Code636 · Post by **Code636** » Sat Dec 15, 2001 4:41 am

latest dos is 6.05

Monty · Post by **Monty** » Sat Dec 15, 2001 5:27 am

Hi:

Actually, the R06.05.00 is NO LONGER
Availible, it now subs to a Windows Based
platform on CD Ver R01.05.14 ( RPX4719G )
Dated 8/24/01

Monty

<font size=-1>[ This Message was edited by: [email protected] on 2001-12-15 08:28 ]</font>

Post by **wavetar** » Sat Dec 15, 2001 1:20 pm

True, but the latest updated DOS version comes with the Windows CPS as well, since the CPS will do MTS2000s ONLY. All other MT2000/MTX8000/838s are still DOS only.

Todd

medic1020 · Post by **medic1020** » Mon Dec 17, 2001 1:10 am

interesting... i believe i used ver 6.5 and it said that i needed to use a later ver. Any takes on that?

Allan

OX · Post by OX » Mon Dec 17, 2001 3:38 am

That's odd, I used CPS once and didn't care for it (so I'm a DOS man...) and after programming my MTS with it and it causing problems, I was able to read my MTS with the 6.05 and write it with no probs.

Make sure you have 6.05.

Post by **wavetar** » Mon Dec 17, 2001 4:56 am

On 2001-12-17 04:10, medic1020 wrote:
interesting... i believe i used ver 6.5 and it said that i needed to use a later ver. Any takes on that?

Allan

So which was it? 6.00.00, or 6.05.00? There were several in between as well. Double check it.

medic1020 · Post by **medic1020** » Mon Dec 17, 2001 4:40 pm

I'm sorry for the confussion. It had vs. 6.0 not 6.5 I guess I'm otta luck with this one. Thanks for all the good advice everyone!

Allan

jjmcrowell · Post by **jjmcrowell** » Tue Dec 18, 2001 9:00 am

medic1020, check your private messages...