ANOTHER HI-ROSE QUESTION

[mancow]

OK, does anyone have any info on the pin outs on these. Mine is set up like this...
The round connector has six connections in a circle. The radio connector part has 9 pins and looks like this if looking at the connector pins on the hi-rose
00 O <---- antenna pins and mount screw.

x 0 0
x 0 0
0 0 0
x 0 0

x= no pin

The top of the seal cap shows a pair of head phones. I'd like to build an adapter to interface a neweagle tactical head set to this but I don't have any schematics or pin outs. If anyone can help with the literature or details I would appreciate it and would try to make it worth your time.


Thanks.

[Will]

Is this an adaptor used on the Saber radios?
Most of them had the standard HiRose connections to match many accessories that have the HiRose ala EXPO radio accessory connector.

I make adaptors that go in-between the HiRose and your tac headset connector.

[mancow]

Hi Will, that's what I was trying to do but it's a pain becase the head set has a bendix king plug on the end and I can't hack it off since it belongs to the department.
What I was needing was a pin out diagram for the hi rose connector I guess. I took the side jack parts off an old bendix/king and made a female adaptor to plug the head set into. I now need the part # for the plug that goes into the HI-ROSE and a wiring diagram.


later.

[jimbrissie]

Check out these websites for help:

Hirose Electric: The connector is one of the HR10 series. They make panel mount & inline males and females. They have a pdf catalo with all the specs and part numbers.
http://www.hirose.com/hiroseusa.htm

Digikey: Distributor for Hirose, stocks a lot of stuff.
http://www.digikey.com/

Hirose / Expo Schematic: Thanks to msisco9939 http://batboard.batlabs.com/viewtopic.p ... 89&forum=1

I used all these sources for a Hirose to Jedi adapter I made.

Hope this helps

Jim Brissie

<font size=-1>[ This Message was edited by: jimbrissie on 2002-01-23 09:39 ]</font>