Page 1 of 1
Motorola MTSX MVA Pinout
Posted: Fri Jan 20, 2012 10:52 am
by benni473
Hello,
i have got a Motorola NTN1340A MTSX Radioholder and a NTN1322B RF Connect Box but no cables.
Does anyone have a Pinout from the Interconnectcable between Holder an Connector Box??
Thanks!
Benni
Re: Motorola MTSX MVA Pinout
Posted: Fri Jan 20, 2012 12:14 pm
by fineshot1
benni473 wrote:Hello,
i have got a Motorola NTN1340A MTSX Radioholder and a NTN1322B RF Connect Box but no cables.
Does anyone have a Pinout from the Interconnectcable between Holder an Connector Box??
Thanks!
Benni
It is here on the batlabs web site - see below
http://www.batlabs.com/mtsx.html
BTW: The NTN1322B is a basic control unit (no rf amp) for the NTN1340 with no RF connections.
Re: Motorola MTSX MVA Pinout
Posted: Fri Jan 20, 2012 1:27 pm
by benni473
Hi,
I need the Control Unit Pinout, e.g. Ignition.. (no Infos on Batlabs about this Unit).
Thanks!
Benni
Re: Motorola MTSX MVA Pinout
Posted: Mon Jan 23, 2012 1:31 pm
by fineshot1
benni473 wrote:Hi,
I need the Control Unit Pinout, e.g. Ignition.. (no Infos on Batlabs about this Unit).
Thanks!
Benni
You will need to get a hold of a NKN6453A or NKN6454A i/f cable
and ohm it out to see if it is a straight through cable.
If it is a straight through cable then you have your answer.