Syntor X9000 cable mic low pin question

The General forum is where users can discuss any topic regarding Motorola communications equipment - hardware, software, etc. There are also several focused forums on this board, so please take the time to ensure that your questions doesn't fall into one of those categories before posting here!

Moderator: Queue Moderator

Post Reply
radiocat37
Posts: 210
Joined: Mon Sep 22, 2003 9:59 am

Syntor X9000 cable mic low pin question

Post by radiocat37 »

I recently obtained a syntor X9000 control head cable with a training wire attached to pin 13 (Mic Low) at the radio side. Can anyone advise why there would be a set-up like this? I cannot find where it may need to be grounded or connected to something.

Thanks
Brian Griffin: Ah, if my memory serves me, this is the physics department.
Chris Griffin: That would explain all the gravity.
.

Lois: Peter, you're drunk again.
Peter: No, I'm just exhausted because I've been up all night drinking.
Top
Will
Posts: 6823
Joined: Tue Sep 04, 2001 4:00 pm

Re: Syntor X9000 cable mic low pin question

Post by Will »

I can not think of any reason for the added wire. Just cut it off near the connector and insulate the end of the wire.
Top
Post Reply

Return to “General Motorola Solutions & Legacy Radio Discussion”