cdm codeplug cloneing

The General forum is where users can discuss any topic regarding Motorola communications equipment - hardware, software, etc. There are also several focused forums on this board, so please take the time to ensure that your questions doesn't fall into one of those categories before posting here!

Moderator: Queue Moderator

Post Reply
STEVE W
Posts: 172
Joined: Mon Sep 03, 2001 4:00 pm

cdm codeplug cloneing

Post by STEVE W »

This may have been asked before but, can a 40 watt 6an CDM1550+ from a 25 watt 6an or do I have to do all the programming manually
Thanks
Steve
Top
Jim202
Posts: 3610
Joined: Sun Sep 09, 2001 4:00 pm

Re: cdm codeplug cloneing

Post by Jim202 »

STEVE W wrote:This may have been asked before but, can a 40 watt 6an CDM1550+ from a 25 watt 6an or do I have to do all the programming manually
Thanks
Steve


I believe that if you start 2 software programs at the same time, you can click and drag the information from one radio to the other. Then write to the new radio with the info you dragged from the original radio. Then go into the new radio and clean up the scan channel information and personalities.

Jim
Top
User avatar
escomm
Queue Moderator
Posts: 5170
Joined: Fri Mar 24, 2006 8:24 pm

Re: cdm codeplug cloneing

Post by escomm »

There is no drag and drop in the Pro Series CPS. You will need to copy the info over.
Top
Post Reply

Return to “General Motorola Solutions & Legacy Radio Discussion”