Page 1 of 1
MTR2000 and Narrow Band
Posted: Sat Oct 20, 2012 6:19 am
by arlojanis
I reprogrammed a MTR2000 for narrow band and now there is intermittant noise keying the repeater. Repeater is PL. Does the squelch need adjusting after going narrow band?
Re: MTR2000 and Narrow Band
Posted: Sat Oct 20, 2012 6:25 am
by Bill_G
You should check everything after narrowbanding. I've found I have to kick up the deviation a tad, and tighten the squelch. I do the whole procedure.
Re: MTR2000 and Narrow Band
Posted: Mon Oct 22, 2012 8:07 am
by d119
Also make sure your receiver qualifiers are set properly (AND/OR), etc.
Re: MTR2000 and Narrow Band
Posted: Tue Nov 06, 2012 12:43 pm
by commcheck
I have found the squelch needs to be tightened up a bit after narrowbanding.
Re: MTR2000 and Narrow Band
Posted: Thu Nov 08, 2012 3:20 pm
by thebigphish
recreate the codeplug from scratch when making that change, be wary about download -> change -> upload.