XTS3000 ASTRO25 Channel ID Problem

[Muxlow]

SO!
My XTS3000 800mhz is flashed for 9600 baud and trunking and such. SO! It should be doing what i want it to. I have done the exact same setup for a XTS2500 and for whatever reason its not letting me in the ASTRO Saber/XTS CPS

Flash is 548008-000480-9

ASTRO IMBE Digital Operation
Enhanced Digital ID Display
Hardware Multikey Encryption
Trunked One Touch Status Message
SmartZone Systems Operation
SmartZone Omnilink MultiZone Operation
ASTRO 25 9600 Baud Trunking

Now when i load my system key i can do everything i need to other then under the Trunking Systems/ASTRO 25 Channel ID.
I cant edit anything in there. Can on the 2500, cant on the 3000. Another thing different on the 2500 is in the 700/800 ASTRO 25 Control Channels on the 3000 it only has Channel ID Number (cant edit it) and RX frequency. On the 2500 it has RX and TX frequency plus i can edit the channel id number under that tab

What could be causing this? The system im trying to do does not use the default bandplan and since i cant change it.. of course its not working.
I need to edit the Channel bandwidth TX Offset, Channel Spacing and base Freq. When i move my mouse over them i get the little glasses

Using ASTRO Saber & XTS3000 CPS R05.03.00

Anyone have any ideas?

[Mfire39]

What Host firmware does the radio in question have?


-Marc

[Muxlow]

Host; R06-72.00
DSP N08.03.05

[Muxlow]

I'll assume that the XTS3000 just cant do it? That i was never ment to have Astro25 and was kinda of forced in and the default badnplan settings cant be edited?