Batboard

Hi,
I was programming 7 CDM1550SLS+ uhf and one of them simply died after programming. Basicly it never booted up again after the reboot signal was sent after the programming. Any idea if it's a common thing or i hit a bad apple ? Radio is no longer under warranty... They all have the same options, and serial numbers are following each others so they're from the same batch.

did you try hooking up ignition sence to pin 10 ?

put power to pin 10 on the back and see if that brings it back to life? You might of selected ignition sense in the programming

i tried with no luck..