Page 1 of 1
CDM1550 LS+ not able to program
Posted: Mon Apr 22, 2013 12:45 am
by aerosox
I'm using the 5 in 1 Motorola Programming cable to program the CDM1550 LS+ and CPS software used is Waris R06.12.05.
Problem is it kept prompt that "Could not open port, Check whether the Device/RIB are powered on or not....." but i manage to read and write all my handhelds with the same cable (GP338/GP338Plus/HT1250/GP638Plus/GP328/GP328Plus)
Re: CDM1550 LS+ not able to program
Posted: Mon Apr 22, 2013 2:49 am
by aerosox
Using Asus EEEPC 1000HA with Windows 7 Ultimate 32bit, i used RS232 to usb adapter as i don't have serial port
Re: CDM1550 LS+ not able to program
Posted: Mon Apr 22, 2013 5:37 am
by SteveC0625
aerosox wrote:I'm using the 5 in 1 Motorola Programming cable to program the CDM1550 LS+ and CPS software used is Waris R06.12.05.
Problem is it kept prompt that "Could not open port, Check whether the Device/RIB are powered on or not....." but i manage to read and write all my handhelds with the same cable (GP338/GP338Plus/HT1250/GP638Plus/GP328/GP328Plus)
The same cable? Those are all portable radios and use a cable that connects on the remote mic connector. The CDM's need a cable that has an RJ45 or RJ50 on the radio end to plug into the mic connector.
Re: CDM1550 LS+ not able to program
Posted: Mon Apr 22, 2013 6:29 am
by aerosox
SteveC0625 wrote:aerosox wrote:I'm using the 5 in 1 Motorola Programming cable to program the CDM1550 LS+ and CPS software used is Waris R06.12.05.
Problem is it kept prompt that "Could not open port, Check whether the Device/RIB are powered on or not....." but i manage to read and write all my handhelds with the same cable (GP338/GP338Plus/HT1250/GP638Plus/GP328/GP328Plus)
The same cable? Those are all portable radios and use a cable that connects on the remote mic connector. The CDM's need a cable that has an RJ45 or RJ50 on the radio end to plug into the mic connector.
the one i'm using is this, it has the RJ45 cable with 4 pin outs on it
