BPR40 resets to default programming

[arlojanis]

I have seen two Mag One BPR40's reset to default programming while being used in the field. Have any others seen this? Was it caused by low voltage from a bad switch or battery?

[Al]

Factory reset is a "feature" built into the firmware on the BPR40 according to the service manual. You press and hold both the PTT and lower programmable button then powerup the radio. A good key chirp tone signals completion of the reset. I've had it happen to a customer after his kids played with the radio.

[thpthp123]

Oh wait a minute.... "Service Manual" is mentioned... Where, oh where, did you get a service manual for the MAG ONE bpr40? Please, oh please, tell me... it's not available from the big "M"...

[com501]

A stuck bottom button along with an inadvertent PTT press at power on will cause this. What? You can't d/l the manual from MOL anymore?