sys saber 3 inop keypad

The General forum is where users can discuss any topic regarding Motorola communications equipment - hardware, software, etc. There are also several focused forums on this board, so please take the time to ensure that your questions doesn't fall into one of those categories before posting here!

Moderator: Queue Moderator

Post Reply
chiefops
Posts: 59
Joined: Sat Sep 22, 2001 4:00 pm

Post by chiefops »

have sys saber 3 whose codeplug was corrupted. repaired codeplug and programmed several zones and modes- now keypad won't work. while likely keypad shield is ng, anything else i should look for?
if i have to replace keypad shield, whats the part #?
is it cheaper to flat rate it?
will motorola repair a systems saber without causing grief?
Top
Post Reply

Return to “General Motorola Solutions & Legacy Radio Discussion”