Page 1 of 1
Posted: Fri Feb 22, 2002 5:54 pm
by ArmsonOeg
Does anyone know what the problem is on my system?? I Have 2 High Powered Spectras U and V. It was originally on my VHF But i had switched it to my UHF Everything works but the External Radio. I just checked it before posting stills does not work. Yes i checked the programming everything looks to be in order.Im i missing something?...Thanks Gordon
Posted: Fri Feb 22, 2002 9:48 pm
by apco25
If your siren dek is set up like mine, one of the buttons is programed as on/off and will activate whatever was last selected or is the default tone. So if I want exrad to work, I select it and then hit the dek enable button and it works. Wail is my default tone so if I turn on the dek without selecting EX RAD the siren will activate.
Posted: Sun Feb 24, 2002 9:15 pm
by bls106
That could be embarrassing / interesting! Especially if you're a "vol'y" pulling up behind a Trooper.
I don't think that he'd see the humor in it though. I hope that the rest of you do though.
Posted: Mon Feb 25, 2002 7:18 pm
by PCSAR 4x4 652
I have mine setup to boot up in "LAST STATE" so EXRAD is selected by default at startup. this would be F2, F9, F7 in the RSS. If you have the A9 heads you can remove the DEK and program the Head to do siren/pa functions.
You still have to hit SIREN to turn on the EXRAD and siren tones. The only functions that should work on a one button entry is PA, MAN, and AIRHORN, MAN and AIRHORN being momentary on/off.
_________________
T. Freeman
PCSAR 4x4 Unit 652
PCSAR TAC Unit 705
<font size=-1>[ This Message was edited by: PCSAR 4x4 652 on 2002-02-25 22:19 ]</font>
Posted: Tue Feb 26, 2002 12:24 pm
by ArmsonOeg
Well when it was on my VHF all i had to do is Push the ExRd to route audio outside then push again to remove it. But now if ExRd is pushed it locks on and does not do anything but lite up under the button, i also have to push the Manual Button to get out of ExRd. When it warms up a bit here i will swap them and see what happens.... As far as LAST State i dont think mine will do ExRd only AirHorn and the Siren Tones........Gordon
Posted: Tue Feb 26, 2002 9:43 pm
by PCSAR 4x4 652
when you go to the RSS go f2,f9,f6. it should be like this:
public address
option audio routing disabled
P.A. Ign Sense enabled
EXRD ign sense enabled
default PA volume level 9
Siren/PA after reset last state
Siren
tones enabled
Manual siren tone airhorn
Siren Ign Sense enabled
on the DEK is your exrad button programmed as exRad A or ex rad B?
A is siren on/off
B is standalone