Jedi Series Rapid Charger Question

The General forum is where users can discuss any topic regarding Motorola communications equipment - hardware, software, etc. There are also several focused forums on this board, so please take the time to ensure that your questions doesn't fall into one of those categories before posting here!

Moderator: Queue Moderator

Post Reply
Tabull
Posts: 27
Joined: Wed Sep 26, 2001 4:00 pm

Post by Tabull »

Have a rapid charger which was working fine and just stopped. No obvious "injury" to the board and the wall adapter is putting out the spec'd 16VDC. Does anyone have schematic or any troubleshooting suggestions for this???? Internal fuse??? Diode???? Please reply to [email protected] if you want to reply private. Thanks
Top
Will
Posts: 6823
Joined: Tue Sep 04, 2001 4:00 pm

Post by Will »

There are three different versions. The big M says it is NOT repairable, but you can look in the service manual for the radio and it mite have the diagram there. Two versions were the same circuit as the GP300/350/P110 rapid chargers. Usally the contacts fail, get dirty or bent, the power jack breaks loose from the board, and the regulator on some overheats. Surface mounted componets and a microprocessor make it hard to work on.
Top
Post Reply

Return to “General Motorola Solutions & Legacy Radio Discussion”