Page 1 of 1
Posted: Sun Mar 17, 2002 10:02 am
by wavetar
I have just recently tried my hand at hex editing the RSS to allow the MTX8000 to accept frequencies higher than it's default 865.9875 upper limit. I have followed the instructions on BatLabs, and the numbers have changed when viewing the .ODB file, but I still cannot program in any higher frequencies (same out of band error pops up). I would appreciate it if anyone with some insight to my problem could offer it, either on the board or off. Many thanks,
Todd
Posted: Sun Mar 17, 2002 2:20 pm
by wavetar
Jeezus...just to show everyone how stupid I can be...I had copied my entire MTSX directory to MTSXtest, so I could experiment on the .OBD file in that folder. I forgot that running the MTSX.bat file in that folder would still run the original MTSX program, not the hacked one!! Turns out my hacked version does exactly what I want it to. Thanks to Allan for his response off board as well.
Todd
Posted: Mon Mar 18, 2002 1:35 pm
by Yosh
Leave it to Todd to answer his own questions! Thanks Todd - you're a real asset to this board...
-Yosh