Crown Vic 1998 Ignition Point

KuhnElectronics · Post by **KuhnElectronics** » Wed Feb 23, 2005 10:43 am

Where is a good place to grab 12v switched ignition on a 1998 Crown Vic Police Package???

Thanks,

Nick

KuhnElectronics · Post by **KuhnElectronics** » Wed Feb 23, 2005 11:04 am

Two wires near passenger kick panel? Will those work?

Wile E. Coyote · Post by **Wile E. Coyote** » Wed Feb 23, 2005 12:50 pm

It's been a while, but I remember a red, and a blue connector in the kick pannel. Red is battery, and blue is ignition.

Wed Feb 23, 2005 5:22 pm

That is correct. The are about 10 guage or so if I remember correctly. They sometimes terminate on a 3 unit plug in type of connector on each wire to make installs go somewhat easier.

FFParamedic571 · Post by **FFParamedic571** » Thu Feb 24, 2005 1:27 pm

Kuhn.. Have you ever worked on a PI before?

commtek · Post by **commtek** » Fri Feb 25, 2005 4:09 pm

Apparently not

KuhnElectronics · Post by **KuhnElectronics** » Fri Feb 25, 2005 8:27 pm

I have been doing installs for a few years now, but mostly Personal Vehicles, Fire & EMS apparatus, and ect. I did my first radio install in a PI a few months ago, but there was already wiring terminated in the console, so it was simple. I knew there was such wiring pre-installed for this, but no idea where to look.

I have 30 PI's to do some install and uninstall work to in the next 4-5 weeks. I am just trying to get as much information as possible. When your only 17 its hard for some people to take you seriously when you ask questions like this so I appreciate the help.