pr400 software

jmr3865 · Post by **jmr3865** » Sun Nov 27, 2005 6:49 pm

I am just wondering if it is hard to get. I want to get it legally through motorola. Part #'s?

Al · Post by Al » Sun Nov 27, 2005 7:45 pm

The whole commercial series including the CM200,300, CP150, 200 and PM400 and PR400 are programmed with the RVN4191G CPS. The most recent version is 5.02 I believe. Since this CPS requires the RLN5596A license(same as the HT750/1250/1550 and CDM series) I would assume that it's essentially unobtainable by many people. However the licensing requirement should not stop you from "throwing your hat into the ring".

jmr3865 · Post by **jmr3865** » Mon Nov 28, 2005 2:07 pm

I am licensed for ht1250 software. Thanks.

ICEMANTIM · Post by **ICEMANTIM** » Mon Jan 16, 2006 11:29 am

Hello
I have the software for the pr400. We purchased it when we got the radios. We have ver 5.00.
We just got somemore raadios. We would like to program them the same as the old ones. When i read the older radios everything works fine. When i try and clone to the newer radio i get and error #2412 asking to check the radio and com port settings. It workes for the older radio but not the new one. Do the new ones have a differant version of software. Any ideas.
Thanks Tim