Comtegra power pinout needed

carbineone · Post by **carbineone** » Thu Dec 01, 2005 11:19 am

Does anyone have the pinout for the din power connector on the comtegra?

Mikey · Post by **Mikey** » Thu Dec 01, 2005 7:07 pm

If your looking at the connector on the back the top left is pin 3 then going down is pin 5 , then pin 2 (right at bottom) then pin 4 , and last is pin 1 (on the far upper right) I have had luck powering the Comtegra by using 12V. DC + on Pin 5 and 12V. - on pin 4 . (the pins are straight across from one another. If this is too confusing give me a fax machine and i will fax you the schematic for the power supply section thanks to one of the other BatLabs members one here for the Schematic.

Mikey

carbineone · Post by **carbineone** » Fri Dec 02, 2005 3:45 am

Mikey that works
Thank you very much for the help