Batboard

Hello. I was wonding what, if installed, would the encryption board be/look like on the inside of an XTS3000. I am not familiar of the insides of an XTS3000 whatsoever, so I would need to know where on the board I would be able to locate it as well.

Thanks for any help.
Ray.

it is located under the controller board, under where the keypad goes

Would that be under the silver sheild?

you need to remove the 4 clips that hold the keypad on, remove the keypad, remove the controller board, flip it over and it plugs into J601

Well, when i open up my XTS3000, there is a silver sheild near the botton of the radio. Again, I am not familiar with the inside of an XTS3000, so, you would need to tell me what/where the vocon is. Under the keypad part (where it would be; this is a Model I) there is a silver sheild, which looks like it could be removed. Looks like how the inside of an HT1000 is, I guess.

Sorry, I thought I read that it was a model 3. Yes, remove the metal shield. It should be held on with 4 clips. Take out the controller board, filp it over and plug it in.

K8TEK, Check your PM's.

Thanks.