Minitor V: scanning and SV conflict

PNGR1209 · Post by **PNGR1209** » Tue Dec 27, 2005 9:58 am

I have determined through trial and error that if you program your Minitor V to scan 2 channels, when there is an alert the SV will not record very much because if the carrier drops briefly after the alerting tone pair or between tone pairs, the scan resumes and the SV stops recording.

I had mine set up for normal (probability) scan and dynamic SV length with delayed revert.

So now if I want to make sure I get the whole page recorded by the SV I keep the pager on monitor or selective call, switching to scan only after the dispatch is over.

If someone knows how to work around this I would love to hear it.

Birken Vogt · Post by **Birken Vogt** » Tue Dec 27, 2005 12:46 pm

Just a guess but have you tried setting the message duration to a fixed length?

Birken

PNGR1209 · Post by **PNGR1209** » Tue Dec 27, 2005 2:02 pm

Yes. Message length does not matter apparently, SV stops recording.

tvsjr · Post by **tvsjr** » Tue Dec 27, 2005 10:35 pm

Nope, I've got about a dozen M5s set up as follows:
Silent Scan
Dynamic SV length
Revert N at about 6 seconds (pager takes 6 seconds of carrier loss to revert)

Works just fine, and our dispatchers ALWAYS drop carrier between the tone set and the dispatch traffic. Are you running the latest programming software and have you flashed to the latest firmware, just for shits?

PNGR1209 · Post by **PNGR1209** » Wed Dec 28, 2005 4:51 am

Firmware and PPS are the latest 12.1.05 release.

DJP126 · Post by **DJP126** » Wed Dec 28, 2005 5:18 am

Is the pager set for PRIORITY SCAN or non-priority? My guess is you have it set to priority. If it's set to non-priority, it shouldn't resume scanning until there is no carrier.

PNGR1209 · Post by **PNGR1209** » Wed Dec 28, 2005 6:22 am

I had it on non-priority (probability scan), and I suspect you may be right. I'll try it out in priority when I get a chance.