I am looking for codeplug for ht1000 vhf with DTMF front cover
Thanks
codeplug for ht1000 vhf with DTMF
Moderator: Queue Moderator
Are you trying to convert from a non-DTMF front?
It's pretty simple to do in HexEditor. Go to: http://www.batlabs.com/visar.html and about halfway down the page is the procedure.
It's pretty simple to do in HexEditor. Go to: http://www.batlabs.com/visar.html and about halfway down the page is the procedure.
JAYMZ
"Mom and dad say I should make my life an example of the principles I believe in. But every time I do, they tell me to stop it."
Calvin
"Mom and dad say I should make my life an example of the principles I believe in. But every time I do, they tell me to stop it."
Calvin
-
HLA
- Posts: 2334
- Joined: Mon Jul 11, 2005 8:15 pm
- What radios do you own?: HT1550's, X9000's, CDM1550's
what version of the radio do you have? you can email me your codeplug and i'll fix it for you.
HLA
I never check PM's so don't bother, just email me.
I won't reply to a hotmail, gmail, aol or any other generic free address, if you want me to reply use a real address.
STOP ASKING ME FOR SOFTWARE OR FIRMWARE, I JUST FORWARD ALL OF THE REQUESTS TO THE MODERATORS
I never check PM's so don't bother, just email me.
I won't reply to a hotmail, gmail, aol or any other generic free address, if you want me to reply use a real address.
STOP ASKING ME FOR SOFTWARE OR FIRMWARE, I JUST FORWARD ALL OF THE REQUESTS TO THE MODERATORS
-
RadioSouth
- Batboard $upporter
- Posts: 2884
- Joined: Mon Sep 03, 2001 4:00 pm
Before you bit bang look at the model specific page on the HT1000. It gives info. on using 'The Special Programming Mode' to enable DTMF. It tells you it only works on radios that came with this option from the factory but I can tell you using this method I've enabled over a dozen radios this way that started off as non-DTMF radios, worked evert time I tried it.