Can I make a 1250 out of a 1250 LS or LS+?

Jammer · Post by **Jammer** » Wed Jan 04, 2006 5:00 pm

Is it possible to copy the codeplug from a 1250 to a 1250 LS or LS + and get the increased conventional channel capability?

Obviously there must be some hardware differences, but has anyone done this?

elkbow · Post by **elkbow** » Wed Jan 04, 2006 7:51 pm

i don't think thats possible....

Josh · Post by **Josh** » Thu Jan 05, 2006 12:41 am

No, that won't work... the software will see a mismatch in serial number and model number and not allow it

Post by **wavetar** » Thu Jan 05, 2006 4:40 am

No, I'm quite sure it won't work. A while back, a member tried to convert a "5AN" mobile into a "6AN" mobile model using the dual ribless/Y-cable procedure outlined on Batlabs.

Afterwards, the CPS showed it as having a "6AN" model number, but none of the "6AN" features (MDC, extra conventional channels, etc) were enabled.

Todd