Page 1 of 1
Can I make a 1250 out of a 1250 LS or LS+?
Posted: Wed Jan 04, 2006 5:00 pm
by Jammer
Is it possible to copy the codeplug from a 1250 to a 1250 LS or LS + and get the increased conventional channel capability?
Obviously there must be some hardware differences, but has anyone done this?
Posted: Wed Jan 04, 2006 7:51 pm
by elkbow
i don't think thats possible....
Posted: Thu Jan 05, 2006 12:41 am
by Josh
No, that won't work... the software will see a mismatch in serial number and model number and not allow it
Posted: Thu Jan 05, 2006 4:40 am
by wavetar
No, I'm quite sure it won't work. A while back, a member tried to convert a "5AN" mobile into a "6AN" mobile model using the dual ribless/Y-cable procedure outlined on Batlabs.
Afterwards, the CPS showed it as having a "6AN" model number, but none of the "6AN" features (MDC, extra conventional channels, etc) were enabled.
Todd