Page 1 of 1
CP1250 Cradle - Part #????
Posted: Wed Feb 01, 2006 7:46 am
by RADIO43
Anyone know the part number on the programming cradle for the CP1250? Thanks in advance.
Radio43
Posted: Thu Feb 02, 2006 11:52 am
by Fuel4300
The programming cradle is:
0162481S01
and the cradle plus software and manual is:
PDVN4008A
Both are showing cancelled on MOL.
Fuel
Posted: Thu Feb 02, 2006 4:12 pm
by RADIO43
Tahnks for the help Fuel4300... Radio43
Posted: Mon Apr 17, 2006 7:21 am
by otter9309
I have two leads from an advisor cradle, and it worked fine.
Posted: Tue Apr 18, 2006 7:18 am
by EEnerd
I was wondering, in general- why you couldn't just use an advisor (or whatever) programming cup and extend the leads to any pager? Don't most all Motorola pagers use a serial interface? I think i remember older pagers using 3 connectors; TX/RX/GND, whereas some newer ones use a 2 pin arrangement; GND and a bidirectional pin which would require commoning the TX/RX pins on the programming cup.