Help - Minitor V Programming set up....

This forum is focused on discussing Digital and Voice paging equipment, protocol's, infrastructure, and Motorola specific hardware used. Please refrain from discussing different ways to monitor the digital paging systems due to the legalities of such.

Moderator: Queue Moderator

Post Reply
User avatar
RADIO43
Batboard $upporter
Posts: 743
Joined: Thu Oct 17, 2002 10:46 pm
What radios do you own?: 900 MHZ APX4000

Help - Minitor V Programming set up....

Post by RADIO43 »

Guys,

I recentley ordered just the programming cradle for the Minitor V. I figured I would be able to use the same rib that I use for the Minitot IV but I am starting to think I am missing something. I noticed there is a power port on the back of the cradle for the Minitor V. Do I need a power supply for this? Do I need a diffrent programmig setup completely? Thanks in advance for the help....



Radio43
Top
Al
Posts: 1045
Joined: Tue Sep 04, 2001 4:00 pm

Post by Al »

The power jack is on the rear of your MV cradle to allow reflashing the MV firmware. You don't need to worry about it for everyday programming. The MV requires the same equipment(UPI, serial PC cable, coilcord, and wallwart) used to program the Minitor III and IV(except for the cradle, of course).
Top
User avatar
RADIO43
Batboard $upporter
Posts: 743
Joined: Thu Oct 17, 2002 10:46 pm
What radios do you own?: 900 MHZ APX4000

Post by RADIO43 »

Awesome...... Thank you..........
Top
Post Reply

Return to “Motorola Digital and Voice Paging”