Saber question

radiogirl · Post by **radiogirl** » Mon Mar 20, 2006 8:34 pm

OK guys, please bear with me and forgive me for not knowing everything about Moto but what do the two (2) buttons on the side of the Saber with the 1 dot and the 2 dots do (. , ..) ?? New to moto and am learning as a hobbyist and ham (expensive). Thanks

DJP126 · Post by **DJP126** » Mon Mar 20, 2006 8:42 pm

Sounds like you have a Saber IE. The two side buttons are the repeater access tone buttons. The are only available with 6B or 8B core programs.

Tom in D.C. · Post by **Tom in D.C.** » Tue Mar 21, 2006 5:40 am

He meant to say 6D and 8D core radios, not B.

The buttons are programmable for things such as emergency call, and on
the 5D core (most common) radios they don't do anything. Some of the early
Saber cases don't even have these buttons.

All of the later Saber cases had these buttons, Saber I, II, III, and I-E.

DJP126 · Post by **DJP126** » Wed Mar 22, 2006 4:09 pm

Tom in D.C. wrote:He meant to say 6D and 8D core radios, not B.

Thanks Tom. Must have been a long day

k4wtf · Post by **k4wtf** » Sat Mar 25, 2006 1:48 pm

Every saber I've ever owned or seen has the same two buttons on the side. It's not limited to the 1E series.

RESCUE161 · Post by **RESCUE161** » Sat Mar 25, 2006 10:55 pm

I've got one Saber case that does not have the two buttons. I only keep it around 'cause it's in good condition.

DJP126 · Post by **DJP126** » Sun Mar 26, 2006 6:50 pm

k4wtf wrote:Every saber I've ever owned or seen has the same two buttons on the side. It's not limited to the 1E series.

I never said that the side buttons were limited to the 1E. I said that it sounds like he had a 1E because he said...

OK guys, please bear with me and forgive me for not knowing everything about Moto but what do the two (2) buttons on the side of the Saber with the 1 dot and the 2 dots do (. , ..) ??

k4wtf · Post by **k4wtf** » Mon Mar 27, 2006 4:10 pm

OK. I can see where you could get 1E from that if she was describing the Batwing selector switch vs the buttons. If I'm not mistaken (don't have a saber in front of me) there are dots on or near the RAT buttons as well.

AEC · Post by **AEC** » Mon Mar 27, 2006 10:47 pm

The first release Sabers did not have the two RAT buttons below the PTT, but shortly after, they started appearing on later release radios, most are non functioning due to early CORE/COPE versions of the radios, but since they mfd. radios with updated CORE/COPE, it was simpler to just have one case style and use that.

I've also had cases without the RAT buttons, but sinc ei've never had use for them, they are simply another piece of rubber that will rip sometime in the future and allow moisture ingress into the frame.

Enterprise.....One to beam up!

Saber question

Saber question

Saber...

Re: Saber...