UPGRADING TO A 6.15 MLM IN A HI POWER UHF

boem2134 · Post by **boem2134** » Thu Apr 20, 2006 1:32 pm

Hello all I have a hi power spectra with an A9 head that currenty has a 5.23 MLM I have a 6.15 MLM that came out of a 800mhz deck, I need to bit bang into the UHF so I may enable zones. Can anyone explain to me in 3rd grade lanquage how to do this, I have the moflag lists but am a little confused on how to start. do I insert the new MLM and bit bang my current model number into it or how?

PLEASE HELP.

THANKS TO EVERYONE

Robert

Post by **escomm** » Sun Apr 30, 2006 4:24 pm

Send me the MLM and 25 bucks. I'll put it in my radio and make it a 100 watt A7 or A9.

NOTE: IF I make it an A9 high power, direct mode selection with a DEK will NOT work. Thanks, Moto.

JAYMZ · Post by **JAYMZ** » Sun Apr 30, 2006 6:35 pm

If it's still available try and take the Command Board too... This way the feature strings are all the same.

Next... go to my site with a nifty little tutorial on taking care of your model number and such.

http://www.k2jsv.com/spectra

Before you start, right down your tuning values and such... you'll need them later, or a complete tuning will be needed.

Go in and change your model number in both places, serial number(if you want it to match the tags) bandsplit, and control head type. At that point you should be good to go. If by some strange coincidence you hose your MLM let me know. I have one if you need to replace it on a command board.