HT1250 Power off problem

n3obl · Post by **n3obl** » Tue May 16, 2006 9:57 pm

Got an HT1250 that when you shut off the display comes back to life however the radio does not TX, change ch's, clock does not blink etc. but the display is lit up with what ch it was on.

Just flashed to 05.08.03 from 04.00.01

Frank N3OBL
FF/EMT

n3obl · Post by **n3obl** » Tue May 16, 2006 10:38 pm

Newest thing changed in programming config.

Switch CPS from 6.05 to 6.06 and using a polaris PAII

RIB worked fine with other radios incuding MCS2000

Frank

n3obl · Post by **n3obl** » Wed May 17, 2006 3:25 pm

HELP!!!!!! anybody

Frank

Garyf629 · Post by **Garyf629** » Thu May 18, 2006 8:16 am

Have you tried reflashing the radio? Try an older flash if you have one. What is the model #?

n3obl · Post by **n3obl** » Thu May 18, 2006 9:58 am

Only older flash i have is 5.04

This is very weird.. Never had any problem..(before)

Frank

Vercomm · Post by **Vercomm** » Thu May 18, 2006 10:03 am

I would try the newest firmware and see what happens.

The newest for the NON-4-LINE radio is R05.09.13

If you like email me and I can send you the PDF files on what it fixes.

Jamie

n3obl · Post by **n3obl** » Thu May 18, 2006 10:11 am

Got another one.. Radio powers on and off normally. However when removing programming cable it comes on (DISPLAY)

Frank

Garyf629 · Post by **Garyf629** » Thu May 18, 2006 1:32 pm

When attaching the programming cable the radio automaticly turns on. I always turn the radio on first, before attaching the cable. Are you turning the radio on/off with the cable attached? If you are, remove the cable, then try turning it on/off.

n3obl · Post by **n3obl** » Thu May 18, 2006 7:18 pm

I usually try to make sure the radio is turned on first. However i got two radios exhibiting similar power off problems.

Frank