CDM Firmware

[Vercomm]

Does anybody have the PDF file on the procedure to flash a CDM. I have downloaded the profession portable instructions and both of the comercial series but can't find the CDM PDF file on MOL. Can somebody email me a copy.

Thanks,

jamie

[email protected]

[HLA]

it's pretty simple, just follow the instructions on the screen.

1. Power on the radio. If the ignition is on, turn off all other accessories to
ensure the quietest possible environment. Do not run the engine during this
procedure.
2. Connect the AARKN4081B programming cable to the microphone jack of the radio.
The Programming cable is connected to the adapter, and the adapter is
connected to the computer through the 25 to 9 pin converter.
3. If your using a laptop ensure that "Transmit Buffer" in the Advanced Port Settings
window is not positioned at the highest setting. See troubleshooting section
"Adjusting Transmit Buffer" below for details.
4. Make sure that the switch in the HLN9742B adapter is in the OFF position.
5. Start the Firmware/Codeplug Upgrade Kit from the 'Start Menu'.
6. Once the upgrade screen appears, press the PROGRAM button.
7. For the first attempt of upgrade after the tool is launched, the flash baud
rate selection dialog will appear. Select a baud rate and press OK button.
8. A message box will appear with instructions to put the radio in bootstrap
mode.
- Throw the switch on the flash adapter to the B position
- Press the radio On/Off button twice (wait 1 second between presses).
NOTE: the radio should not respond to the two presses and there will be
no change in the display.
9. After clicking Ok, upgrading should begin if properly put in bootstrap mode.
10. When the process is complete, return the flashing switch to the OFF position
before disconnecting the cable from the radio or powering it up. The radio
will power off when the cable is removed.
11. Connect another radio and repeat from step 5. Remember, the baud rate
selection is done only the first time after starting up the program.
12. After upgrading all radios, remove the flashing adapter.

NOTE:
1) Do not remove the programming cable or turn off the radio while
upgrade is in progress.
2) In case of failure during the upgrade, a message box will appear to
guide the user to recover from the failure IF possible.
3) The flashing rate can be changed only by restarting the program.
4) You may not run more than one copy of the program at the same time.