help programming Gp680

This forum is for discussions regarding all aspects of Motorola radio programming, including hardware, computers, installation and use of RSS/CPS, firmware upgrades, and troubleshooting. There are subforums for discussions of codeplugs, and also for software/firmware release notes and issues.

Moderator: Queue Moderator

Post Reply
albe01
Banned
Posts: 7
Joined: Wed Jul 12, 2006 5:40 am

help programming Gp680

Post by albe01 »

Hi, I would want to program the transmitter-receiver but I do not find the program adapted, I have a program much old one, even if program the frequencies the radio does not transmit, I have only menus status, add contact, delete contact. I would have to only program 6 channels for amateur radio operator bridges but I do not succeed.
Thanks :(
Top
User avatar
JAYMZ
Posts: 2778
Joined: Sun Sep 09, 2001 4:00 pm
What radios do you own?: Radar Range

Post by JAYMZ »

Sounds like you need to call Motorola and buy the latest software.
JAYMZ

"Mom and dad say I should make my life an example of the principles I believe in. But every time I do, they tell me to stop it."
Calvin
Top
Andreas
Posts: 626
Joined: Sun Sep 09, 2001 4:00 pm
What radios do you own?: radios

Post by Andreas »

If you can read and write the radio without any errormessage,the RSS is ok.You have to fill in the frequencies and set to "repeater talkaround".
After programming,you have to set the radio to conventional mode.
Another way is to flash the radio to GP380 and the radio will do up to 250 channels and select-5 and single tone call (to open a repeater).
You can find much more informations about all on my homepage.
Use the Email address on my homepage for replies.

Andreas
Last edited by Andreas on Thu Jul 13, 2006 1:33 am, edited 1 time in total.
Top
albe01
Banned
Posts: 7
Joined: Wed Jul 12, 2006 5:40 am

Post by albe01 »

The program not errors, but I do not trust myself to program it to gp380, I would not want to damage the radio, and I do not know not even where to find the necessary one. i have only rib rln4008 and the cable.
radio ver.no:R.02.00.22
mdh25rdh9ck6ae I using motorola cps software R00.02.10, 29May 2001
(sorry for my bad english)
I'd' like programming the radio only for this amateur frequncy,
Ch1: rx 430150 tx431750
Ch2: rx 430175 tx431775
ch3 rtx 433075
:oops: ???
on display i have only status menu, contact list, the other menu' are missing :roll:
help!
Top
albe01
Banned
Posts: 7
Joined: Wed Jul 12, 2006 5:40 am

Post by albe01 »

albe01 wrote:The program not errors, but I do not trust myself to program it to gp380, I would not want to damage the radio, and I do not know not even where to find the necessary one. i have only rib rln4008 and the cable.
radio ver.no:R.02.00.22
mdh25rdh9ck6ae I using motorola cps software R00.02.10, 29May 2001
(sorry for my bad english)
I'd' like programming the radio only for this amateur frequncy,
Ch1: rx 430150 tx431750
Ch2: rx 430175 tx431775
ch3 rtx 433075
:oops: ???
on display i have only status menu, contact list, the other menu' are missing :roll:
help!
i not have found conventional mode and personality selection menu'! :roll:
Top
Post Reply

Return to “Radio Programming”