Operation Question - Spectra

Jimfire · Post by **Jimfire** » Thu Jul 27, 2006 12:15 pm

I just reprogrammed my Spectra and went from a pre-defined scan list to a user-definable scan list.

Without the owner's manual, I'm not sure how to set up the scan lists for each mode via the front panel. I'm sure it can't be too difficult.

Anyone care to share this little bit of wisdom?

Thanks,

JIM

jmr061 · Post by **jmr061** » Thu Jul 27, 2006 12:39 pm

You hold down the scan button and until it beeps. Then toggle through each channel and use sel or del to change its status in the scan list. You get one scan list now. Thats it. Each mode does not have its own scan list.

Jason