CDM1550 boot up problem

This forum is for discussions regarding all aspects of Motorola radio programming, including hardware, computers, installation and use of RSS/CPS, firmware upgrades, and troubleshooting. There are subforums for discussions of codeplugs, and also for software/firmware release notes and issues.

Moderator: Queue Moderator

Post Reply
cduda
Posts: 200
Joined: Sun May 21, 2006 9:39 am
What radios do you own?: GP300, HT1250, CDM1250

CDM1550 boot up problem

Post by cduda »

I have 5 CDM1550 radios. all the same model and everthing. All have the same exact codeplug. One on, when you turn the batteries on (firetruck), it does not boot to the primary revert channel, Zone 1, Channel 1. All of the other 4 do no problem but one. Again...all the radios are identical with identical codeplugs. The one in question, 1 time will boot to channel 4, zone 1, next time channel 11, zone 1, just what ever. Any ideas?
Top
User avatar
rrfd43
Posts: 434
Joined: Wed Mar 06, 2002 4:00 pm
What radios do you own?: Cobra 25 LTD Classic with echo

Post by rrfd43 »

Check the power set up. The radio needs the power leads to an unswitched 12 volt source and the ignition sense to a switched source. Saw this a lot with other series radios that had main power to the switch. All of our CDM's are now wired the proper way and have no power on issues.
Top
Post Reply

Return to “Radio Programming”