cos specs

This forum is for discussions regarding all aspects of Motorola radio programming, including hardware, computers, installation and use of RSS/CPS, firmware upgrades, and troubleshooting. There are subforums for discussions of codeplugs, and also for software/firmware release notes and issues.

Moderator: Queue Moderator

Post Reply
anautofix
Posts: 57
Joined: Fri Jan 06, 2006 11:09 am

cos specs

Post by anautofix »

I am making a repeater out of a 16 pin M10 for RX and a maxtrac 50 for TX. I am using an ICS repeater controller and it needs to know the COS on and off voltage for the receiver. Where can I find this info? Or does anyone know?? THx

You can e-mail me [email protected]
Top
User avatar
wavetar
Administrator
Posts: 7341
Joined: Sun Sep 09, 2001 4:00 pm

Post by wavetar »

Pin 8 in the M10 should by default be approx 5-volts DC when not receiving a signal, and zero volts when receiving.

Todd
No trees were harmed in the posting of this message...however an extraordinarily large number of electrons were horribly inconvenienced.

Welcome to the /\/\achine.
Top
Post Reply

Return to “Radio Programming”