Batboard

I bought a Astro Spectra 800 MHz from ebay,it's suppose to be a 800 Smartzone,Model # D04UJF9PW5AN 1 MEG Flashcode 500008-000000-1 and powers up with no fail codes.
When I run a check by powering it up and pressing the home button 5 times,this is what I get:
First ER9\10
1-AMR0701
2-M0500128
3-EMCR0000
4- 1 None
5- 2 None
6-the model and serial numbers and then it stops in the RF TEST MODe

Would I be right in saying I got screwed.

Max

Error 9/10 just means it's been told that it has a crypto module, but there is in fact no module present or the module has failed. That would be in line with lines 3-5 (no firmware revision, no keygroups).

Best way to verify this would be to pull the radio and see if the crypto module is present.

Does the radio power up normally?

The HOST/DSP numbers look a little skewed, might verify them. What does the RSS/CPS say when you read the radio, if you can?

Sounds like you got a hack job. The flashcode doesn't match the host/dsp. Host/dsp would indicate its an early model analog only radio, the host is vselp era but the M in the dsp indicates its analog only dsp. Someone rammed an imbe flashcode into it.

Jason

Ebay golden rule #1 was broken.

Not only do you have to know what questions to ask....

YOU HAVE TO ASK THEM BEFORE BIDDING


you were e-screwed on that AS bud.



doug

Thanks guys for all your input.
I can read the radio with DOS,and it tx and rx on anolog no problem,trunking and conventional.So if i understand what your telling me,is this radio will not do digital,and it's been hacked.
Max

When i read and write the radio i get the ER01\10,for about 2 seconds then it shows what i have programmed into it.
Max

Max wrote:When i read and write the radio i get the ER01\10,for about 2 seconds then it shows what i have programmed into it.
Max

I think you meant ER09/10.

From the main menu press F4-->F3-->F2. On the bottom right hand of the screen, you should see "Secure Hardware Equipped.....Yes". Change it to "No" and the error code will go away.

Todd