cm300 corrupted? error#2411

DPYWDN · Post by **DPYWDN** » Wed Sep 13, 2006 1:37 pm

Just tried to read a new cm300 using a AARKN4081B cable with a FKN8096A adapter in cps mode, running cps ver. 5.03.00. Cps states error #2411 - corrupted code plug.
Is my radio now dead or is this just motorola's way of telling me to update my software.

Post by **escomm** » Wed Sep 13, 2006 1:57 pm

Current CPS version is 05.05, so it's most likely the latter.

MotoMax300 · Post by **MotoMax300** » Wed Sep 13, 2006 3:30 pm

Send me the codeplug, I have the most current and will test it here as well for you.

DPYWDN · Post by **DPYWDN** » Wed Sep 13, 2006 4:12 pm

The radio is new, never been programmed. Tried to do the first read and received the error #2411. Any suggestions?

Post by **escomm** » Wed Sep 13, 2006 4:38 pm

Yeah, get the current CPS.

DPYWDN · Post by **DPYWDN** » Wed Sep 13, 2006 5:31 pm

Sounds right. Thanks

HLA · Post by **HLA** » Fri Sep 15, 2006 11:45 am

it's probablly not the cps, it would say codeplug too new if that was the case. are you shure you had the adaptor in normal mode and not flash mode at any time you were trying to read or write to the radio? what is the exact model number. it's possible that you can write a different codeplug into the radio and overwrite what's in it.

Post by **escomm** » Fri Sep 15, 2006 11:48 am

Actually the CP/CM series won't say that the codeplug is too new.

I had a handful CP200 and CP150 go to the depot for service and were returned with the newest firmware (3.0 I believe) and when I tried to use the old software for giggles it returned a corrupted codeplug error. Used the latest software and it read fine.

Same thing happened with some BPR40s that had the 01.01 firmware, software did not mention that the codeplug was too new and instead returned an error message about a corrupted codeplug.

DPYWDN · Post by **DPYWDN** » Sat Sep 16, 2006 4:13 pm

Loaded up ver 5.05 and all is well again. Thanks for taking the time to reply all.